0
- See All KTM
- Adult
- Backpack
- Blind valve
- Brake lever
- Brake pedal
- Cap
- Carpet
- Chain guide
- Chain tensioner
- Chair
- Clutch basket, lamella, other
- Clutch cover
- Cross dress
- Cross pants
- ERM / ECU / ECU REFLASH
- Fan
- Flask
- Foil / Sticker
- Front wheel axle
- Fuel filter
- Full top armor
- Gaskets
- Helmet
- Jacket
- Lifter/clamper
- Lock-on - fastener
- Louvers
- Needle roller
- Off/On switch
- Others
- Part
- Pump
- Radiator guards
- Rear brake disc
- Rear brake pad
- Resonator/Header
- Seal
- Seat
- Sensor
- Shift lever
- Spoke set
- Sticker full set
- Street
- T-shirt
- Umbrella
- Upper cylinder guard
- Vest

- See All Two Stroke Performance (TSP)
- ERM / ECU / ECU REFLASH
- Gaskets / Rings
- Head Inserts
- Ignitions
- Injector Relocation Kit
- MAP Switch
- Offset Flywheel Key
- Oil Pump Delete Kit
- Other Heads
- Other Powerkits
- Rebuild Kits
- TBI Heads
- TBI Powerkits
- Tools / Fittings
- TPI Goodies
- TPI Heads
- TPI IRK Powerkits
- TPI Powerkits

-
- Featured
-
-
- Featured
-
-
- Featured
-
Our webshop expands weekly with new products
Expert advice for all your motorcycle needs
Numerous special offers await you!
A wide range of motorcycle protectors to keep your bike safe
Free shipping on orders over 30,000 HUF within Hungary*
Premium quality motorcycle apparel for maximum safety and comfort.
Built at the request of snow bikers, the Style 6 Triple Clamp Tugger mounts to the top triple clamp and extends vertically above the handlebar to provide a convenient location to grap your snow bike even when buried in the white stuff. Constructed using two layers of Tugger webbing with an internal stiffener to handle the worst abuse. (Sorry – custom embroidery is not available due to the stiffened construction.) Easy to install, lightweight, tough, and convenient. Backed by our no-nonsense After riding with the Tugger™, you’ll never want to ride without one again. Weight: 3 oz!
Can be purchased separately but snow bikers recommend the Snow Bike 3-Pack (Style 1 EE, Style 2 EE, and Style 6).
Instructions:
1. Remove one top triple clamp bolt. Use the top bolt for max height, the lower one if you want the Tugger a little lower.
2. Decide if the stock bolt can be used, if not, use one of the bolts included in your Tugger kit. You may need to cut the bolt a little shorter for some models.u
3. Slide the Tugger metal end piece over the aluminum bushing, insert the bolt and tighten.
4. Route the Tugger as desired and repeat on the other side.
,
Product Code: | 862219 |
Manufacturer ID: | T6 |
Condition | New |
Stock status | In stock |